|
Could you clarify what Http GSAP is?
<br>
<br>If you want a very simple example of an HTTP step at work in TeleFlow, you can create one with just a single step.
<br>
<br>Go to the "Adv" tab of the Steps Toolbox to find the HTTP step, and put this into a TeleFlow Application. (you could create one with just this step)
<br>
<br>In the step properties, fill in the following:
<br>1) URL: The URL to load. Any web page will do for an example.
<br>2) Make sure the HTTP Request type is set to "Get"
<br>3) Put @HEADER in the "Variable to load HTTP Response Header into" field.
<br>4) Put @RESPONSE in the "Variable to load HTTP Response Message Body into" field.
<br>
<br>Run the application, and look at the log. You should see the html source for the web page content.
|
