|
In order to use TeleFlow switching on an NMS platform, the following settings must be in effect:
<br>
<br>AG.CFG
<br>
<br>For every board in the system, the following statement must be present
<br>
<br>EnableMvip = YES
<br>
<br>
<br>SwitchPath
<br>
<br>With MVIP enabled, the NMS boards no longer have default connections between the network resources and the DSP’s. In this state, a board will not answer the phone or place calls. In order to create the initial connections, the NMS utility “SWISH” must be run every time the board is started:
<br>
<br>SWISH {SwitchPath script file}
<br>
<br>Examples:
<br>
<br>SWISH qt1cas.swi NMS sample for a single quad-T1 card (AG-4000, AG-QT1)
<br>SWISH ag8.swi enGenic sample for a single AG-8 card
<br>SWISH ag8_and_t1.swi enGenic sample for an AG-8 and AG-T1 in the same computer
<br>
<br>Note: You may have to write a specific SwitchPath script file for your NMS installation.
<br>
<br>
<br>TeleFlow Config
<br>
<br>The Telephony Hardware setting in TFConfig must be "NMS Communications"
|
