Post new topic Reply to topic  [ 4 posts ] 

Board index : TeleFlow Forums : NMS Communication Boards

Author Message
 Post subject: Config for MNS AG4040
PostPosted: Wed May 02, 2007 7:16 pm 
Offline

Joined: Tue May 01, 2007 7:17 pm
Posts: 3
Hi all,
please help me to configure " MSN AG4040 card, E1, PRI, isd0, 4ESS".
Thank you so much,
tuanhuynh


Back to top
 Profile  
 
 Post subject: Config for NMS AG4040
PostPosted: Thu May 03, 2007 4:56 pm 
Offline
Site Admin

Joined: Wed Dec 31, 1969 5:00 pm
Posts: 329
Location: Vancouver, BC
The first place you need to look is in the NMS AG 4040 Installation and Developers Manual. Ensure you have the hardware installed correctly according to Chapter 3, then proceed to Chapter 4, "Configuring the Board".

There are 4 steps involved:

(1) Find out the bus/slot number for your card, using the PCISCAN utility.

(2) Create or modify a board configuration file. These are usually placed at C:\NMS\AG\CFG. There are several example files that NMS provides in that folder. I suggest you use the one name "agi4e1pi.cfg". If you card is a quad (4-span) card, this file will likely work without any modifications. If you are using a dual (2-span) card, you will need to change all notations of [0..3] to [0..1]. For a single (1-span) card, the notation would be [0].

(3) Edit the OAMSYS.CFG file (usually found at C:\NMS\OAM\CFG\) to supply the information about your configuration to the NMS OAM service. Here's an example of how to set the fields in this file:

[Board0]
Product = AG_4040_4TE
Number = 0
Bus = 0
Slot = 5
File = agi4e1pi.cfg

4) Run the OAMSYS utility to boot the card.


Back to top
 Profile WWW 
 
 Post subject: Re: Config for NMS AG4040
PostPosted: Thu May 03, 2007 6:57 pm 
Offline

Joined: Tue May 01, 2007 7:17 pm
Posts: 3
Thanks Tim,
I try to follow your step. But, when I run " ctatest -> pc " to place call, I have the error: " CTAERR_INVALID_STATE from nccPlaceCall ". Please, help me resolve this error.
Thanks,
tuanhuynh


Back to top
 Profile  
 
 Post subject: Try running TeleFlow
PostPosted: Tue May 08, 2007 1:03 pm 
Offline
Site Admin

Joined: Wed Dec 31, 1969 5:00 pm
Posts: 329
Location: Vancouver, BC
Instead of using CTATEST, try running TeleFlow. Use the application called "AnswerTest.TAP". Which should answer the phone no matter what protocol you are running underneath.


Back to top
 Profile WWW 
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

Board index : TeleFlow Forums : NMS Communication Boards


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Style by Midnight Phoenix & N.Design Studio
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.