| TeleFlow Forums http://teleflow.org/phpbb/ |
|
| Config for MNS AG4040 http://teleflow.org/phpbb/viewtopic.php?f=3&t=428 |
Page 1 of 1 |
| Author: | tuanhuynh [ Wed May 02, 2007 7:16 pm ] |
| Post subject: | Config for MNS AG4040 |
Hi all, please help me to configure " MSN AG4040 card, E1, PRI, isd0, 4ESS". Thank you so much, tuanhuynh |
|
| Author: | Tim [ Thu May 03, 2007 4:56 pm ] |
| Post subject: | Config for NMS AG4040 |
The first place you need to look is in the NMS AG 4040 Installation and Developers Manual. Ensure you have the hardware installed correctly according to Chapter 3, then proceed to Chapter 4, "Configuring the Board". There are 4 steps involved: (1) Find out the bus/slot number for your card, using the PCISCAN utility. (2) Create or modify a board configuration file. These are usually placed at C:\NMS\AG\CFG. There are several example files that NMS provides in that folder. I suggest you use the one name "agi4e1pi.cfg". If you card is a quad (4-span) card, this file will likely work without any modifications. If you are using a dual (2-span) card, you will need to change all notations of [0..3] to [0..1]. For a single (1-span) card, the notation would be [0]. (3) Edit the OAMSYS.CFG file (usually found at C:\NMS\OAM\CFG\) to supply the information about your configuration to the NMS OAM service. Here's an example of how to set the fields in this file: [Board0] Product = AG_4040_4TE Number = 0 Bus = 0 Slot = 5 File = agi4e1pi.cfg 4) Run the OAMSYS utility to boot the card. |
|
| Author: | tuanhuynh [ Thu May 03, 2007 6:57 pm ] |
| Post subject: | Re: Config for NMS AG4040 |
Thanks Tim, I try to follow your step. But, when I run " ctatest -> pc " to place call, I have the error: " CTAERR_INVALID_STATE from nccPlaceCall ". Please, help me resolve this error. Thanks, tuanhuynh |
|
| Author: | Tim [ Tue May 08, 2007 1:03 pm ] |
| Post subject: | Try running TeleFlow |
Instead of using CTATEST, try running TeleFlow. Use the application called "AnswerTest.TAP". Which should answer the phone no matter what protocol you are running underneath. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|