| TeleFlow Forums http://teleflow.org/phpbb/ |
|
| configuration problem http://teleflow.org/phpbb/viewtopic.php?f=3&t=554 |
Page 1 of 1 |
| Author: | ravindra.rapaka [ Tue Nov 18, 2008 11:13 pm ] |
| Post subject: | configuration problem |
We are working on CG6100C cards, on which we are facing problems in allocating the DSP resources: As per the setup, there are 9 CG6100C cards in a chasis with 2000 MIPS on each. on each board 1,2,3,4,5,9,10,11,12,13 E1's are configured for incoming and 6,7,8,14,15,16 are configured for outgoing. With the cofig file that is attached, i am able to open first 250 cic on each board, for the remaining cics i am receiving nccStartProtocol Failed error. I am opening the following services on each and every cic CTA_SERVICE_DESC noccOpenSvcLst[4] = { {{"NCC", "ADIMGR"},{0},{0},{0}}, {{"ADI", "ADIMGR"},{0},{0},{0}}, {{"VCE", "VCEMGR"},{0},{0},{0}}, {{"SWI", "SWIMGR"},{0},{0},{0}}, }; ctaOpenServices - Success nccStartProtocol - failing ................... from channel 250 on each board is there any thing i need to do programatically and in the config files. Help me out in resolving this issue. |
|
| Author: | Chris [ Thu Nov 20, 2008 12:33 pm ] |
| Post subject: | Re: configuration problem |
The TeleFlow Forums are for TeleFlow issues. To a limited degree, you can get help with hardware configuration as is pertains to running with TeleFlow. TeleFlow does not support the CG6100C card, and as such, you questions would better be taken up with NMS Communications. Thank you. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|