TeleFlow Forums
http://teleflow.org/phpbb/

Missing ISDN Events on DP 3209
http://teleflow.org/phpbb/viewtopic.php?f=4&t=526
Page 1 of 1

Author:  coral [ Wed May 21, 2008 3:32 am ]
Post subject:  Missing ISDN Events on DP 3209

Hi All,

I am using DP 3209 board for developing Voice Logger application.

I am not getting all the ISDN events from the card.
The only ISDN event which the board is detecting is "EVT_CALL_ABANDONED"

On placing a call on trunk, events that are being detected are :
(1)EVT_DIGIT
(2)EVT_MON_SILENCE
(3)EVT_MON_ACTIVITY
(4) EVT_CALL_ABANDONED (On disconnecting the call ).

On SmartControl --> Digital Network --> Signaling Protocol selected is ISDN.
Framing is CRC -4.
Line Coding is HDB3.

Please help me in resolving this issue.

Regards

Vibhor Singhal

Author:  Chris [ Thu May 22, 2008 10:07 am ]
Post subject:  Re: Missing ISDN Events on DP 3209

In SmartWORKS, please verify the following:

Board Tab:
- TDM Encoding is appropriate to your location.
- CT Bus Type: MVIP
- CT Mode: Master

Digital Network: Have you verified with whomever provides the circuit that you have the framing and signaling protocol settings correct? I'm assuming you are using an E1, as well, based on your description?

If any of the above needs to change, you must hit "Apply" in each tab after you make the setting change. After you are finished, restart the computer.

If the settings were already all correct, you might need a crossover cable between the call recording computer/DP 3209 and point of duplication.

Finally, how do you know those are the only events? What are you using to see the events presently?

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/