After i created the tal and tap file and try to run the program with Dialogic D/41D board .In the teleflow monitor the port is turning into yellow colour from the green , i can't find this from the help , from the log the message showing to me is " Querying board ..." then finish . Is the dialogic board i used not supported by teleflow ? But i can find this dialogic model from the "teleflow system setup " and the message show me is need to download the dialogic 5.1 driver and service pack . i have done this but the problem still remain.

Verify that the board is started using the Dialogic Configuration Manager. <br> <br>Also, check that the Horoscope Demo for Dialogic will answer the phone. If it doesn't answer, TeleFlow most certainly won't. Do not run Dialogic's demo AND TeleFlow Server at the same time, either. This is sure to cause problems. <br> <br>Unfortunately, the "teleflow system setup" application has fallen a little out of date. Officially, we do not support any ISA boards on any platform. If the Dialogic demo works, TeleFlow *should* work. Since it is an ISA board, we can make no promises. If the demo works, but TeleFlow is still stuck at the board query, you can send a log to support@engenic.com of the stuck board query. Make the subject line read: DEVNET: Stuck board query <br> <br>If there is anything obvious, someone will respond in this thread. If not, we will likely recommend moving to a newer (PCI) supported board instead.