Post new topic Reply to topic  [ 2 posts ] 

Board index : TeleFlow Forums : Dialogic/Intel Boards

Author Message
 Post subject: 240JCT-T1 Protocol Error
PostPosted: Mon Jan 17, 2011 10:58 am 
Offline

Joined: Mon Jan 17, 2011 10:43 am
Posts: 1
I am trying to setup a evaluation of TeleFlow Enterprise 2010 using a Dialogic D/240JCT-T1 board connected to a PBX via T1 using D4 framing AMI line coding. I have the 6.0 Drivers installed and the demo apps with the drivers work when I call the extension. I get an error "Protocol 'wnk0' not supported" "This feature is not support in this software module" "Please contact Engenic for more information" in the TeleFlow Monitor application. When I use an Analog Dialogic card the evaluation works fine. Thanks


Back to top
 Profile  
 
 Post subject: Re: 240JCT-T1 Protocol Error
PostPosted: Wed Jan 19, 2011 10:25 am 
Offline

Joined: Wed Mar 19, 2003 4:28 pm
Posts: 510
Location: Canada
TeleFlow doesn't have Wink Start protocol support for the Dialogic D-series cards. TeleFlow does support Wink for the CG series.

For Dialogic D-series, you need to use ISDN (isd0 in the TFLineList).


Back to top
 Profile WWW 
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

Board index : TeleFlow Forums : Dialogic/Intel Boards


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Style by Midnight Phoenix & N.Design Studio
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.