Post new topic Reply to topic  [ 2 posts ] 

Board index : TeleFlow Forums : Dialogic/Intel Boards

Author Message
 Post subject:
PostPosted: Mon Mar 13, 2006 12:45 pm 
Offline

Joined: Fri Jul 23, 2004 2:50 pm
Posts: 59
Location: USA
A single phone line will be attached to a 4 port D4PCI card. Since any of the 4 ports may be used, how can TeleFlow be setup for scanning ports looking for one line. Most of the time, once installed, the line will remain in the same port. However, in the event of a problem developing with that port, the connection may be moved to another port requiring TeleFlow to locate the attached phone line. <br> <br>Can this be done automatically from within TeleFlow without slowing down performance. <br> <br>Any suggestion would be appreciated...


Back to top
 Profile WWW 
 
 Post subject:
PostPosted: Tue Mar 14, 2006 3:24 pm 
Offline

Joined: Wed Mar 19, 2003 4:28 pm
Posts: 510
Location: Canada
Will this be for an inbound (telephone answering) or outbound (call placing) system? <br> <br>TeleFlow doesn't really have any way to "scan" for a phone line. Since there is a very low chance of needing to switch lines for a bad port anyway, I would recommend that you just change the configuration to use a different port if this should ever occur. It only takes a minute, and is probably faster than any other solution.


Back to top
 Profile WWW 
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

Board index : TeleFlow Forums : Dialogic/Intel Boards


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Style by Midnight Phoenix & N.Design Studio
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.