I am trying to setup a evaluation of TeleFlow Enterprise 2010 using a Dialogic D/240JCT-T1 board connected to a PBX via T1 using D4 framing AMI line coding. I have the 6.0 Drivers installed and the demo apps with the drivers work when I call the extension. I get an error "Protocol 'wnk0' not supported" "This feature is not support in this software module" "Please contact Engenic for more information" in the TeleFlow Monitor application. When I use an Analog Dialogic card the evaluation works fine. Thanks

TeleFlow doesn't have Wink Start protocol support for the Dialogic D-series cards. TeleFlow does support Wink for the CG series.

For Dialogic D-series, you need to use ISDN (isd0 in the TFLineList).