TeleFlow Forums
http://teleflow.org/phpbb/

240JCT-T1 Protocol Error
http://teleflow.org/phpbb/viewtopic.php?f=5&t=984
Page 1 of 1

Author:  wilja92 [ Mon Jan 17, 2011 10:58 am ]
Post subject:  240JCT-T1 Protocol Error

I am trying to setup a evaluation of TeleFlow Enterprise 2010 using a Dialogic D/240JCT-T1 board connected to a PBX via T1 using D4 framing AMI line coding. I have the 6.0 Drivers installed and the demo apps with the drivers work when I call the extension. I get an error "Protocol 'wnk0' not supported" "This feature is not support in this software module" "Please contact Engenic for more information" in the TeleFlow Monitor application. When I use an Analog Dialogic card the evaluation works fine. Thanks

Author:  Chris [ Wed Jan 19, 2011 10:25 am ]
Post subject:  Re: 240JCT-T1 Protocol Error

TeleFlow doesn't have Wink Start protocol support for the Dialogic D-series cards. TeleFlow does support Wink for the CG series.

For Dialogic D-series, you need to use ISDN (isd0 in the TFLineList).

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/